Fix Your Stuff Community Store

MacBook Pro 17" Unibody Lower Case Replacement

Introduction

Remove the lower case to access most components in your MacBook Pro 17" Unibody.

What you need

  1. MacBook Pro 17" Unibody Lower Case Replacement, Lower Case: step 1, image 1 of 1

    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm Phillips screws.

    • Seven 3 mm Phillips screws.

    Edit

  3. MacBook Pro 17" Unibody Lower Case Replacement: step 2, image 1 of 2 MacBook Pro 17" Unibody Lower Case Replacement: step 2, image 2 of 2

    • Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.

    • During reassembly, carefully align the lower case and then press it firmly until both clips engage.

    • Remove the lower case.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

19 other people completed this guide.

One Comment

Is there a DIY on replacing the rubber feet?

retrotechpost - Reply

Add Comment

View Statistics:

Past 24 Hours: 3

Past 7 Days: 7

Past 30 Days: 34

All Time: 17,854